NEW QUESTION 1
Which of the following would MOST likely be used to obtain electronic images of a large number of printed documents?

• A. NFC device
• B. ADF/flatbed scanner
• C. Camera/webcam
• D. QR scanner

Answer: B

NEW QUESTION 2
A technician powers on a PC and its monitor and sees the following error message:
No input signal detected
The display lights on the computer are on. Which of the following is a possible solution?

• A. Changing the BIOS settings
• B. Changing the connector setting on the monitor
• C. Checking the power plug on the monitor
• D. Checking the power plug on the PC

Answer: B

NEW QUESTION 3
A technician needs to fix a Cat 5 cable issue. The cable, which is connected to a network jack, fails when it is moved around. Which of the following items must the technician use to fix the issue?
(Select TWO).

• A. Scissors
• B. Network tap
• C. Magnetized screwdriver
• D. Tone generator
• E. RJ45 connector
• F. Crimper

Answer: AE

NEW QUESTION 4
A technician is setting up a new desktop computer and will be installing the hard drive directly on the motherboard without using cables to connect it. Which of the following will the technician be installing?

• A. Thunderbolt
• B. eSATA
• C. M.2
• D. SCSI

Answer: A

NEW QUESTION 5
A technician is configuring a workstation to be used as a VM host. After installing the necessary software, the technician is unable to create any VMs. Which of the following actions should be performed?

• A. Disable the BIOS password.
• B. Enable TPM.
• C. Enable multithreading.
• D. Enable Fast Startup.

Answer: B

NEW QUESTION 6
An office manager reports that a printer is experiencing performance issues. Printouts are smudging when they are handled, and. recently, whenever the manager tries to print oversized documents, the paper jams before anything is printed on it.

• A. Yes
• B. Not Mastered

Answer: A

NEW QUESTION 7
A laptop has been returned for a screen repair. The owner insists the screen is broken, but occasionally a faded image is able to be seen in very bright settings on the desktop. Which of the following steps should the repair technician take FIRST?

• A. Replace the graphics card.
• B. Replace the screen, as the customer insists.
• C. Recommend the usage of an external display instead.
• D. Ensure the backlight is functioning as expected.

Answer: D

NEW QUESTION 8
An engineer is experiencing unexpected reboots on a graphics workstation when rendering complex 3-D models. The workstation is configured with a 115V power supply that is rated at 200W and connected to a UPS. The central processing unit contains 16 hyperthreaded cores, and a discrete graphics solution utilizing an 8-pin power connector is installed in a PCI Express x16 slot. Which of the following indicates where the technician should begin troubleshooting?

• A. The UPS, as 115V is insufficient for the configuration and should be increased to 220V
• B. The power supply, as 200W is insufficient when the GPU is heavily tasked
• C. The graphics card, as it is the component that triggers the unexpected reboots
• D. The motherboard, as only standard PCI slots should be used for high-end graphics cards, not PCI Express slots

Answer: B

NEW QUESTION 9
Which of the following network devices is used to separate broadcast domains?

• A. Switch
• B. Wireless access point
• C. Router
• D. Hub

Answer: A

NEW QUESTION 10
A technician goes to a classroom to troubleshoot a projector that occasionally powers off. The technician recreates the issue and notices the projector will not power back on until approximately 15 minutes have passed. After 15 minutes of being powered on. the projector shuts off again. Which of the following should the technician perform NEXT to resolve the issue?

• A. Clean the filter.
• B. Adjust the standby timeout.
• C. Check the power cable connection.
• D. Replace the bulb.

Answer: A

NEW QUESTION 11
A technician installed a Cat 5 UTP cable approximately 275ft (84m) from a network switch in an office to a workstation located on a factory floor The technician sees both a flashing green LED and a flashing orange LED on the workstation's NIC. Which of the following should the technician do FIRST?

• A. Check for loose connections, pinched bends, and physical damage.
• B. Install a powered hub as close as possible to the halfway point in the Cat 5 UTP cable run.
• C. Replace the entire run of Cat 5 UTP cable with Cat 5 STP cable.
• D. Upgrade the entire cable run to multimode fiber.

Answer: A

NEW QUESTION 12
A user acquired a new workstation and is attempting to open multiple targe Excel files simultaneously. The user is not experiencing the expected performance when executing such large requests. Which of the following should a technician do FIRST?

• A. Increase the swap partition.
• B. Upgrade the CPU in the workstation.
• C. Upgrade the power supply in the workstation.
• D. Upgrade the RAM in the workstation.

Answer: D

NEW QUESTION 13
A technician installed a Cat 5 UTP cable approximately 275ft (84m) from a network switch in an office to a workstation located on a factory floor The technician sees both a flashing green LED and a flashing orange LED on the workstation's NIC. Which of the following should the technician do FIRST?

• A. Check for loose connections, pinched bends, and physical damage.
• B. Install a powered hub as close as possible to the halfway point in the Cat 5 UTP cable run.
• C. Replace the entire run of Cat 5 UTP cable with Cat 5 STP cable.
• D. Upgrade the entire cable run to multimode fiber.

Answer: A

NEW QUESTION 14
Which of the following should the data center hardware technician implement to ensure maximum uptime for customers' virtual machines?

• A. Line conditioner
• B. AC voltage regulator
• C. Uninterruptible power supply
• D. Cloud storage backup

Answer: C

NEW QUESTION 15
A technician needs to add storage to a workstation. The workstation does not have room to add any internal storage, so the technician plans to add an external storage device. Which of the following connection types should the technician MOST likely use?

• A. SCSI
• B. eSATA
• C. PCIe
• D. NVMe

Answer: B

NEW QUESTION 16
......