NEW QUESTION 1
Which router can be used for disk-in-access to the router CLI management purposes and does not usually pass normal network traffic?

• A. AUX
• B. Gigabit Ethernet
• C. Fast Ethernet
• D. Channelized serial

Answer: A

NEW QUESTION 2
Refer to the exhibit.

What can be determined about the router from the console output?

• A. No configuration file was found in NVRAM.
• B. No configuration file was found in flash.
• C. No configuration file was found in the PCMCIA card.
• D. Configuration file is normal and will load in 15 seconds.

Answer: A

NEW QUESTION 3
Which two locations can be configured as a source for the IOS image in the boot system command? (Choose two.)

• A. RAM
• B. NVRAM
• C. flash memory
• D. HTTP server
• E. TFTP server
• F. Telnet server

Answer: CE

NEW QUESTION 4
Which Ethernet interface command is present when you boot a new Cisco router for the first time?

• A. speed 100
• B. shutdown
• C. ip address 192.168.1.1 255.255.255.0
• D. duplex half

Answer: B

NEW QUESTION 5
What is the difference between a CSU/DSU and a modem?

• A. A CSU/DSU converts analog signals from a router to a leased line; a modem converts analog signals from a router to a leased line.
• B. A CSU/DSU converts analog signals from a router to a phone line; a modem converts digital signals from a router to a leased line.
• C. A CSU/DSU converts digital signals from a router to a phone line; a modem converts analog signals from a router to a phone line.
• D. A CSU/DSU converts digital signals from a router to a leased line; a modem converts digital signals from a router to a phone line.

Answer: D

NEW QUESTION 6
DRAG DROP

• A. Mastered
• B. Not Mastered

Answer: A

Explanation:
The correct answer is: Router(boot)# Router(config-if)# Router(config)# Router#
Rommon> Router>

NEW QUESTION 7
When using a modem to provide out-of-band access to a Cisco router, which cable is used to connect the modem to the router?

• A. DB-25 to RJ-45
• B. RJ-45 to RJ-45
• C. RJ-44 to RJ-45
• D. DB-9 to RJ-45
• E. DB-45 to RJ-45

Answer: A

NEW QUESTION 8
Which command initiates copying the saved configuration of a Cisco device to a TFTP server?

• A. copy running-config tftp
• B. copy startup-config tftp
• C. copy tftp running-config
• D. copy tftp startup-config

Answer: B

NEW QUESTION 9
Which of the following best describes the cable that is used to connect a laptop to the Console port on a Cisco router?

• A. crossover
• B. straight-through
• C. fiber
• D. rollover

Answer: D

NEW QUESTION 10
Which two pairs of LAN Ethernet devices use an RJ-45 Straight-through cable? (Choose two)

• A. Switch to switch
• B. Switch to router
• C. Switch to server
• D. Router to router
• E. Switch to hub

Answer: BC

NEW QUESTION 11
Which two of the following are true? (Choose two)

• A. Telnet is preferred over SSH for security reasons.
• B. SSH is a protocol that provides a secure remote access connection to network devices.
• C. When using HyperTerminal to communicate over a TCP/IP network, the SSH protocol is used.
• D. A Telnet network management connection is dropped when a router reboots.
• E. Telnet is a protocol that provides a secure remote access connection to network devices.

Answer: BD

NEW QUESTION 12
Which IOS layer does a server use to keep track of which application communications in which conversation?

• A. Transport
• B. Network
• C. Session
• D. Application

Answer: C

NEW QUESTION 13
Which command is necessary to permit SSH or Telnet access to a cisco switch that is otherwise configured for these vty line protocols?

• A. transport type all
• B. transport output all
• C. transport preferred all
• D. transport input all

Answer: D

NEW QUESTION 14
Which two of the following are installed fiber-optic connectors? (Choose two)

• A. subscriber
• B. crossover
• C. multi-dimension
• D. Lucent

Answer: AD

NEW QUESTION 15
Which command sends an echo request packet to the largest host and then waits for an echo response message?

• A. telnet
• B. connect
• C. access
• D. echo
• E. ping

Answer: E

NEW QUESTION 16
Which of the following best describes the port on a laptop that is used to connection to an Ethernet port on a Cisco Switch?

• A. RJ-45
• B. RJ-11
• C. VGA
• D. DVI
• E. DB-9

Answer: A

NEW QUESTION 17
Which windows-based text editor is preferred when working with a simple text document such as a Cisco configuration?

• A. Microsoft Excel
• B. Microsoft Word
• C. Microsoft Notepad
• D. Microsoft Access

Answer: C

NEW QUESTION 18
Refer to the exhibit.

Of which cable type this an example?

• A. RJ-45 straight-through
• B. RJ-45
• C. RJ-45 rollover
• D. RJ-11
• E. RJ-45 crossover

Answer: E

NEW QUESTION 19
Which type of memory stores the decompressed form of the Cisco IOS software and the running configuration?

• A. Flash
• B. ROM
• C. DRAM
• D. NVRAM

Answer: C

NEW QUESTION 20
The enable secret command is used to secure access to which CLI mode?

• A. global configuration mode
• B. privileged EXEC mode
• C. user EXEC mode
• D. auxiliary setup mode

Answer: B

NEW QUESTION 21
......