Get real exam questions for 642-997 Implementing Cisco Data Center Unified Fabric (DCUFI) v5.0. 100% Free.
Q1. Refer to the exhibit. Which statement based on these two outputs that were collected 24 hours apart is true? A. The Site 2 OTV edge device has gone down. B. The MAC address cannot be discovered on two separate port channel interfaces. C. The MAC address that ends in 020a moved to the local site 23 hours ago. D. The Overlay1 IP address should be a multicast IP address. View AnswerAnswer:
Q1. Which statement about scalability in Cisco OTV is true? A. The control plane avoids flooding by exchanging MAC reachability. B. IP-based functionality provides Layer 3 extension over any transport. C. Any encapsulation overhead is avoided by using IS-IS. D. Unknown unicasts are handled by the authoritative edge device. View AnswerAnswer: A Q2. Which two Cisco Nexus platforms support A
Q1. What is effect of the command fabricpath load-balance unicast Iayer3"? A. It configures F2 VDC FabricPath unicast load balancing B. The command automatically load balances broadcast traffic C. It configures F1/MI VDC FabricPath unicast load balancing D. It configures M1 VDC FabricPath unicast load balancing View AnswerAnswer: C Q2. Which statement about SNMP support on Cisco Nexus sw
Q1. Which statement about electronic programmable logic device image upgrades is true? A. EPLD and ISSU image upgrades are nondisruptive. B. An EPLD upgrade must be performed during an ISSU system or kickstart upgrade. C. Whether the module being upgraded is online or offline, only the EPLD images that have different current and new versions are upgraded. D. You can execute an upgrade or down
Q1. Which protocol is responsible for the discovery of FCoE capabilities on a remote switch? A. DCE B. DCBx C. CDP D. LLDP View AnswerAnswer: B Q2. Which two Cisco Nexus platforms support Adapter FEX? (Choose two.) A. Cisco Nexus 7000 Series Switches B. Cisco Nexus 5000 Series Switches C. Cisco Nexus 5500 Series Switches D. Cisco Nexus 4000 Series Switches E. Cisco Nexus 2000 Series
Q1. Which SCSI terminology is used to describe source and destination nodes? A. hosts and targets B. initiators and targets C. HBA and disks D. initiators and disks E. HBA and targets View AnswerAnswer: B Q2. Which topology is not supported when using vPC? A. a single-homed server to a single FEX that is connected to two Cisco Nexus 5500 Series Switches B. a dual-homed server to two FE
Q1. Refer to the exhibit. Which corrective action is taken to resolve the problem? A. Trunk four VLANs on interface ethernet 199/1/1. B. Use the shut and no shut interface ethernet 199/1/1so that the VLANs come up. C. Place interface ethernet 199/1/1 in VLAN 4 in the N5K-2 configuration. D. Prune all but four VLANs from vPC 199. E. Add VLAN 4 to vPC 199. View AnswerAnswer: C Q2. When co
Q1. DRAG DROP View AnswerAnswer: Q2. When configuring FCoE VLANs and Virtual Fiber Channel (vFC) Interfaces, what guidelines must be followed? A. Each vFC interface must be bound to an FCoE-enabled Ethernet or EtherChannel interface or to the MAC address of a remotely connected adapter B. Each FC interface must be bound to an FCoE-enabled Ethernet or EtherChannel interface or to the MAC ad
Q1. Which feature enables NIV? A. EHV B. vPC C. Cisco FabricPath D. Cisco OTV E. VN-Tag View AnswerAnswer: A Q2. Which three items must be configured in the port profile client in Cisco UCS Manager? (Choose three.) A. port profile B. DVS C. data center D. folder E. vCenter IP address F. VM port group View AnswerAnswer: BCD Q3. Which protocol is responsible for the discovery of
Q1. DRAG DROP View AnswerAnswer: Q2. On a Cisco Nexus 7000 Series router, which statement about HSRP and VRRP is true? A. When VDCs are in use, only VRRP is supported. B. HSRP and VRRP both use the same multicast IP address with different port numbers. C. HSRP has shorter default hold and hello times. D. The VRRP group IP address can be the same as the router-specific IP address. View An