Q1.  

What is effect of the command fabricpath load-balance unicast Iayer3"? 

A. It configures F2 VDC FabricPath unicast load balancing 

B. The command automatically load balances broadcast traffic 

C. It configures F1/MI VDC FabricPath unicast load balancing 

D. It configures M1 VDC FabricPath unicast load balancing 

View Answer

Q2. Which statement about SNMP support on Cisco Nexus switches is true? 

A. Cisco NX-OS only supports SNMP over IPv4. 

B. Cisco NX-OS supports one instance of the SNMP per VDC. 

C. SNMP is not VRF-aware. 

D. SNMP requires the LAN_ENTERPRISE_SERVICES_PKG license. 

E. Only users belonging to the network operator RBAC role can assign SNMP groups. 

View Answer

Q3. Which two reasons explain why a server on VLAN 10 is unable to join a multicast stream that originates on VLAN 20? (Choose two.) 

A. IGMP snooping and mrouter are not enabled on VLAN 10. 

B. VLAN 20 has no IGMP snooping querier defined and VLAN 10 has no mrouter. 

C. The mrouter on VLAN 20 does not see the PIM join. 

D. The mrouter must be on VLAN 10 and VLAN 20. 

View Answer

Q4. Which two statements about implementing Cisco NPV and NPIV on a Cisco Nexus 5000 Series switch are true? (Choose two.) 

A. STP must run inside the FP network. 

B. All VLANs must be in the same mode, CE, or FP. 

C. FP port can join the private and nonprivate VLANs. 

D. Only F and M series modules can run FabricPath. 

E. These require an enhanced Layer 2 license to run. 

View Answer

Q5. What is the grace period in a graceful restart situation? 

A. how long the supervisor waits for NSF replies 

B. how often graceful restart messages are sent after a switchover 

C. how long NSF-aware neighbors should wait after a graceful restart has started before tearing down adjacencies 

D. how long the NSF-capable switches should wait after detecting that a graceful restart has started, before verifying that adjacencies are still valid 

View Answer

Q6. Which two items are services that are provided by Cisco Fabric Services? (Choose two.) 

A. device alias distribution 

B. VLAN database distribution 

C. Kerberos proxy distribution 

D. RSA key pair distribution 

E. DPVM configuration distribution 

View Answer

Q7. Which two issues explain why a packet is not being routed as desired in a policy-based routing configuration? (Choose two.) 

A. The route map is not applied to the egress interface. 

B. The route map is not applied to the ingress interface. 

C. The next hop that is configured in the route map is not in the global routing table. 

D. The next hop that is configured in the route map has a higher metric than the default next hop. 

View Answer

Q8. In the dynamic vNIC creation wizard, why are choices for Protection important? 

A. They allow reserve vNICs to be allocated out of the spares pool. 

B. They enable hardware-based failover. 

C. They select the primary fabric association for dynamic vNICs. 

D. They allow dynamic vNICs to be reserved for fabric failover. 

View Answer

Q9. Which three Cisco UCS C-Series CNAs support Adapter FEX? (Choose three.) 

A. Qlogic QLE8152 

B. Broadcom BCM57712 

C. Cisco UCS P81E 

D. Cisco UCS VIC 1220 

E. Emulex OCe10102-FX-C 

F. Intel X520 

View Answer

Q10. Refer to the exhibit. 

Which corrective action is taken to resolve the problem? 

A. Trunk four VLANs on interface ethernet 199/1/1. 

B. Use the shut and no shut interface ethernet 199/1/1so that the VLANs come up. 

C. Place interface ethernet 199/1/1 in VLAN 4 in the N5K-2 configuration. 

D. Prune all but four VLANs from vPC 199. 

E. Add VLAN 4 to vPC 199. 

View Answer