Q1. Following the deployment of a wireless network for data and voice services, an engineer is to validate the coverage. Which type of survey is required to ensure coverage?
A. passive
B. active
C. fingerprinting
D. calibrating
Answer: A
Q2. A customer cannot access the GUI on the Cisco 5508 Wireless Controller from the management interface due to network failure. Which interface can the customer use to access the WLC GUI until the network issues are resolved?
A. virtual
B. dynamic
C. console port
D. service port
Answer: D
Q3. An AP has been configured for personal wireless access to the Internet.
Which item should be configured on the wireless client?
A. RF channel
B. BSS
C. PSK
D. 802.1X/EAP
E. broadcast SSID
F. IBSS
Answer: C
Q4. Refer to the exhibit.
Cisco WCS version 7.0 has a configuration mismatch with what is actually running in the controller. Which menu leads to the Audit Status Report?
A. Security
B. Monitor
C. Configure
D. Services
E. Administration
F. Tools
Answer: C
Q5. When using multiple SSIDs on a lightweight AP, how does the traffic of each SSID reach the 802.3 network?
A. provide routing between them at the core so that the SSIDs can reach the internet
B. configure 802.11q trunking on the Ethernet switch port that is connected to the AP
C. configure ACLs at the switch port that will allow all desired SSIDs to pass traffic
D. configure the SSIDs on the WLC and it will regulate the traffic based on traffic type
Answer: B
Q6. An engineer needs an AP with at least two spatial streams, four receivers, and three transmitters. Which device meets these requirements?
A. 2x4:3
B. 2x3:4
C. 4x3:2
D. 3x4:2
Answer: D
Q7. Refer to the exhibit. The site in this AirMagnet Survey heat map is ready for which level of service?
A. data
B. voice
C. location
D. RFID
Answer: A
Q8. Which Cisco WCS tool allows you to view current reports, open specific types of reports, create and save new reports, and manage scheduled runs?
A. Reports menu
B. Reports launch page
C. Scheduled Run results
D. saved reports
Answer: B
Q9. What three components are required to configure Mobility Group Members between Wireless LAN Controllers? (Choose three.)
A. Controller Management IP Address
B. Controller Virtual IP Address
C. Controller Multicast IP Address
D. Controller MAC Address
E. Controller Mobility Group Name
F. Controller AP Management IP Address
G. Controller RF Group Name
Answer: A,D,E
Q10. Which command path correctly describes how to access and troubleshoot clients with Cisco WCS version 7.0?
A. Tools > Clients > select displayed client's MAC address
B. Tools > Clients > enter client's MAC address
C. Monitor > Clients > click displayed client's MAC address
D. Monitor > Clients > enter client's MAC address
Answer: C