Q1. Which wireless client attempts to authenticate by using 802.1X? 

A. supplicant 

B. authenticator 

C. EAP 

D. RADIUS 

View Answer

Q2. All equipment is operational. Through which two methods can a wireless client receive an IP address when associating to the WLAN? (Choose two.) 

A. The clients can receive an IP address from SW1. 

B. Tie clients can receive an IP address from WLC1. 

C. The clients will not receive an IP address from either DHCP server because of overlapping address ranges. 

D. The clients can receive an IP address in a round-robin maner from either SW1 or WLC1. 

E. The clients can use a static IP address. 

View Answer

Q3. What is the EIRP value for a transmitter that has a transmitter capable of 15 dBm, an antenna that has a gain of 12 dBi, and a cable that connects the transmitter to the antenna that has 1 db loss? 

A. 26 dBm 

B. 100 mW 

C. .86 dBm 

D. 165 dBm 

E. 1000 mW 

View Answer

Q4. Which wireless topology supports roaming? 

A. IBSS 

B. BSS 

C. ESS 

D. bridging 

View Answer

Q5. An engineer wants to deploy a 2504 controller as the anchor controller for a guest WLAN that resides on a 5508 controller in a different mobility group. What configuration change must be applied to support this deployment strategy? 

A. UDP 16666 and IP Protocol 97 must be enabled on the 2504 controller 

B. UDP 5246 and TCP Protocol 97 must be enabled on the router 

C. The 2504 controller must be added to the same mobility group as the 5508. 

D. DHCP Option 43 must be added to the neighboring switchport 

View Answer

Q6. Which Cisco AnyConnect module allows you to set the parameters that are needed to connect to the wireless network? 

A. NAM 

B. DART 

C. posture 

D. telemetry 

View Answer

Q7. An engineer is troubleshooting why wireless clients have not been able to connect to the network. Where would an engineer verify the total number of excluded clients in the last day? 

A. Security > Miscellaneous 

B. Security > Rogues 

C. Alarms 

D. Events 

E. Clients > Troubleshoot 

F. Access Points 

View Answer

Q8. Which CLI command is used on a Cisco WLC to troubleshoot mobility, rogue detection, and load-balancing events? 

A. debug dot11 

B. debug capwap all 

C. show dot11 details 

D. show capwap details 

View Answer

Q9. Refer to the exhibit. 

Which two menus do you click to determine the reachability status of a controller from Cisco WCS? (Choose two.) 

A. Monitor 

B. Reports 

C. Configure 

D. Services 

E. Administration 

F. Tools 

View Answer

Q10. After you configure the Cisco 5508 Wireless Controller v7.6, a customer requests an SSID that allows for client web authentication with email input. Which authentication method should be used? 

A. pass-through 

B. authentication 

C. splash page web redirect 

D. conditional web redirect 

E. on MAC filter failure 

View Answer