Q6. Which two statements are correct when licensing an ESXi 6.x host? (Choose two.)

A. ESXi licenses can be assigned utilizing the ESXi host client.

B. Bulk licensing requires vSphere PowerCLI.

C. Bulk licensing requires vSphere Auto Deploy to be enabled.

D. ESXi licenses can only be applied to ESXi hosts connected to a vCenter Server.

View Answer

Q7. A VMware vSphere 6.x Administrator is implementing a new eight-node cluster for

business critical applications. Each server will be configured with two 10 GbE network adapters and will utilize iSCSI for storage on one subnet.

Which feature is required to implement this solution?

A. Storage DRS

B. LACP

C. Network I/O Control

D. VMkernel Port Binding

View Answer

Q8. Which two options are requirements to perform a migration between vCenter Server instances? (Choose two.)

A. The vCenter Server servers must be time-synchronized.

B. The ESXi hosts must be version 5.5 or later.

C. The vCenter Servers must be version 6.0 or later.

D. The vCenter Server must be in the same single Sign-On domain.

E. The ESXi hosts must have vSphere Standard, Advanced, or Enterprise Plus licensing.

View Answer

Q9. Which three IP addresses may be pinged by the Test Management Network feature in the ESXi hosts DCUI? (Choose three.)

A. NTP server

B. Secondary DNS server

C. DHCP server

D. Default gateway

E. Primary DNS server

View Answer

Q10. A VMware vSphere 6.x Administrator sees the following output in esxtop:

What does the %RDY column represent?

A. CPU Cycle Wait Percentage

B. CPU Utilization

C. CPU Ready

D. Idle CPU Percentage

View Answer

Q11. VM Components Protection (VMCP) can provide automated recovery for which two virtual machine failures? (Choose two.)

A. All Paths Down

B. Permanent Device Loss

C. Firmware failures

D. Driver Failures

View Answer

Q12. Which two options can change the thin provisioned disk to thick provisioned? (Choose two.)

A. Use vMotion to migrate the VM to another ESXi host without moving the disks.

B. Use Storage vMotion of the running VM to the same datastore and select Thick Provision.

C. Power off the VM, locate the VMDK disk in the Datastore browser, right-click that and select Inflate.

D. Use Storage vMotion of the running VM to another datastore and select Thick Provision.

View Answer

Q13. When adding a new VLAN to an existing virtual distributed switch, which three steps are necessary? (Choose three.)

A. Right click the vDS and select Distributed Port Group, then select New Distributed Port Group.

B. Right click on the data center, select Distributed Switch, select New Distributed Switch.

C. Specify the VLAN ID and VLAN type.

D. Provide a name for the Distributed Port Group.

E. Specify the number of physical uplinks form the vDS to the VLAN.

View Answer

Q14. What is the VMware recommended way to distribute storage I/O loads across multiple paths to minimize downtime and remove potential bottlenecks?

A. Enable Storage I/O Control.

B. Configure storage replication.

C. Configure multipathing.

D. Enable storage DRS and configure datastore clusters.

View Answer

Q15. What two options are available when configuring a virtual flash resource on a virtual machine? (Choose two.)

A. Block Size

B. Limit

C. SCSI Controller

D. Reservation

View Answer