aiotestking uk

4A0-100 Exam Questions - Online Test


4A0-100 Premium VCE File

Learn More 100% Pass Guarantee - Dumps Verified - Instant Download
150 Lectures, 20 Hours

4A0-100 Exam Questions and Answers for Alcatel-Lucent certification, Real Success Guaranteed with Updated 4A0-100 Dumps. 100% PASS 4A0-100 Alcatel-Lucent Scalable IP Networks exam Today!

Free demo questions for Alcatel-Lucent 4A0-100 Exam Dumps Below:

NEW QUESTION 1
What are the tasks of a Routing Table Manager (RTM)? (Choose 2)

  • A. To select the best route from among multiple routing protocol
  • B. To select the best route using the metric as criteri
  • C. To send its best route to all its directly connected neighbor
  • D. To install its best route in the routing tabl

Answer: AD

NEW QUESTION 2
The physical networks connecting two PCs to the internet are DSL and PPP respectively. Which layer will enable the two PCs to communicate?

  • A. Layer 1
  • B. Layer 2
  • C. Layer 3
  • D. Layer 4

Answer: C

NEW QUESTION 3
How is Ethernet II different from Ethernet 802.3?

  • A. Ethernet II can be used on broadcast networks where as 802.3 was designed for point-to-point network
  • B. Ethernet II identifies its payload type where as 802.3 indicates the frame lengt
  • C. Ethernet II identifies its frame length while 802.3 indicates the payload typ
  • D. Ethernet II and Ethernet 802.3 are two different names for the same protoco

Answer: B

NEW QUESTION 4
When entering a command on the Alcatel-Lucent 7750 SR from the Command Line Interface (CLI),what would you use to list all the options for the command?

  • A. ?
  • B. tab character
  • C. space character
  • D. info

Answer: A

NEW QUESTION 5
What happens next after an incoming packet is de-encapsulated from the Layer 2 frame in an Alcatel-Lucent 7750 router?

  • A. The IP datagram is encapsulated in the appropriate Layer 2 frame by the MD
  • B. The IP datagram passes through the switch fabric to reach the egress IO
  • C. The IP datagram is passed to the IO
  • D. A lookup is performed in the FIB to determine the egress interfac

Answer: C

NEW QUESTION 6
Which of the following is NOT an example of a Layer 2 protocol?

  • A. POS
  • B. IP
  • C. ATM
  • D. Frame Relay
  • E. Ethernet

Answer: B

NEW QUESTION 7
How does LDP select the path used for an LSP?

  • A. LDP monitors the available bandwidth on all links and signals the LSP based on this informatio
  • B. LDP uses the shortest hop-count between two endpoints for the LS
  • C. LDP must be configured hop-by-hop by the service provide
  • D. LDP follows the path chosen by the IG

Answer: D

NEW QUESTION 8
To transmit its segments of data across the network TCP uses the services of which layer?

  • A. Application Laye
  • B. Transport Laye
  • C. IP Laye
  • D. Data Link Layer

Answer: C

NEW QUESTION 9
Which of the following is a feature of a VLAN?

  • A. A VLAN allows multiple Ethernet switches to be connected in a single broadcast domai
  • B. A VLAN allows multiple Ethernet switches to be connected in a single collision domai
  • C. A VLAN can separate ports on the same switch into different broadcast domain
  • D. A VLAN can separate ports on the same switch into different collision domain

Answer: C

NEW QUESTION 10
Which of the following is NOT a field in a TCP header?

  • A. Source por
  • B. MT
  • C. Sequence numbe
  • D. Acknowledgement numbe
  • E. Window siz

Answer: B

NEW QUESTION 11
A 24 port Ethernet switch is configured with VLAN 100 on ports 1 - 8, VLAN 200 on ports 9
-
16 and VLAN 300 on ports 17 - 24. Which of the following describes the behavior of the switch when a broadcast frame is received on port 1?

  • A. The switch will discard the broadcast frame because there is no specific destination addres
  • B. The switch will flood the broadcast frame on all ports on which the switch has seen frames from attached devices
  • C. The switch will flood the broadcast frame on ports 2 to 8.
  • D. The switch will flood the broadcast frame on all 24 port

Answer: C

NEW QUESTION 12
Based on the network diagram (click on the exhibit),
4A0-100 dumps exhibit
what is the command to use on R1 to setup a static route to the network on CR1

  • A. config router static-route 192.168.2.0/24 next-hop 10.2.3.2
  • B. config router static-route 10.2.3.1 next-hop 192.168.2.0
  • C. config router static-route 192.168.2.0/24 next-hop 10.2.3.1
  • D. config router static-route 10.2.3.2 next-hop 192.168.2.0

Answer: C

NEW QUESTION 13
Which field in the TCP header is used by the receiver to indicate the number of segments it can receive?

  • A. Checksum
  • B. SYN
  • C. Destination port
  • D. Window size
  • E. MTU

Answer: D

NEW QUESTION 14
What operation is performed by an LSR when it receives an MPLS labeled packet?

  • A. The LSR refers to its routing table and forwards the packet to the next LSR or LER without altering the MPLS labe
  • B. The LSR refers to its MPLS label table, swaps the label and forwards the packet to the next LSR or LE
  • C. The LSR refers to its MPLS label table forwards the packet to the next LSR or LER without altering the MPLS labe
  • D. The LSR refers to its MPLS label table, pops the label and forwards the packet to the next IP route

Answer: B

NEW QUESTION 15
Which of the following is typically a characteristic of Layer 2 framing?

  • A. Provides a universal addressing scheme to uniquely identify destinations in the networ
  • B. The size of the Layer 2 frame cannot exceed 1518 byte
  • C. Provides error checking of the frame contents after transmissio
  • D. All the abov

Answer: C

NEW QUESTION 16
Hosts in the same IP network share which common address feature?

  • A. Same host number
  • B. Same IP addres
  • C. First two bits of the IP address are set to 01.
  • D. Same network prefi

Answer: D

NEW QUESTION 17
Which of the following are functions of VLANs? (Choose 2)

  • A. VLANs can group ports on multiple switches into unifiedbroadcast domains
  • B. VLANs allow multiple Ethernet switches to be connected in a single collision domain
  • C. VLANs can separate ports on the same switch into different broadcast domains
  • D. VLANs can group ports on the same switch into different collisiondomains

Answer: AC

NEW QUESTION 18
What is the purpose of TCP flow control?

  • A. It restricts the sender from sending too much data when there is congestion in the networ
  • B. It allows the receiver to control the rate at which the sender transmits dat
  • C. It forces the sender to send only one segment at a tim
  • D. It allows the receiver to drop segments without the sender having to retransmi

Answer: B

NEW QUESTION 19
Which of the following user interface sessions are accessible through Telnet and Secure Shell (SSH) on the Alcatel-Lucent 7750 SR and 7450 ESS?

  • A. Graphic User Interface (GUI).
  • B. Node Management Terminal Interface (NMTI).
  • C. Command Line Interface (CLI).
  • D. All of the abov

Answer: C

P.S. Surepassexam now are offering 100% pass ensure 4A0-100 dumps! All 4A0-100 exam questions have been updated with correct answers: https://www.surepassexam.com/4A0-100-exam-dumps.html (225 New Questions)