NEW QUESTION 1
A unicast packet enters into the front panel port of a leaf switch. The leaf switch performs a forwarding lookup for the packet destination IP address and has a miss result Assuming default configuration, which statement about what happens next is true'?

• A. The packet is sent to the forwardin proxy in the spine switch
• B. The packet is dropped on the leaf switch
• C. The packet is sent to another leaf switch within the same bridge domain
• D. The packet is flooded across the entire fabric because it is an unknown unicast.

Answer: A

NEW QUESTION 2
Which situation causes POAP to auto provision a switch?

• A. The startup configuration is corrupt.
• B. The switch is powered on after being offline for more than 48 hours.
• C. The startup configuration is missing.The startup configuration is corrupt, and you manually rebooted the switch

Answer: C

NEW QUESTION 3
Refer to the exhibit.

Which port is used for communication between the server and the Cisco Integrated Management Controller?

• A. ports on the adapter card
• B. management Ethernet port
• C. LAN on the motherboard port
• D. fabric uplink port

Answer: C

NEW QUESTION 4
Which option must be defined to apply a configuration across a potentially large number of switches in the most scalable way?

• A. a configuration policy
• B. a group policy
• C. an interface policy
• D. a switch profile

Answer: D

NEW QUESTION 5
Refer to the exhibit:

Which option describes the results of running the configuration on a Cisco Nexus 9000 Series Switch?

• A. A schedule'' job named Backup backs up the configuration to a file named backup-cfg.
• B. A scheduler job named backup-cfg runs daily at 2:00.
• C. A scheduler job named Backup runs twice daily
• D. A scheduler job named Backup runs daily at 2 00 and save the configuration to a file named backup-cfg.

Answer: B

NEW QUESTION 6
Refer to the exhibit.

Which type of auto-configuration profile is being configured?

• A. universal configuration
• B. configuration
• C. VLAN
• D. port

Answer: A

NEW QUESTION 7
What occurs when you make an interface a member of an existing VRF m Cisco NX-OS?

• A. The a VRF-Aware services start to be filtered
• B. You are prompted to enter an IP address assignment
• C. All of the Layer 3 configurations are removed
• D. The state of the interface is changed to down

Answer: C

Explanation:
https://supportforums.cisco.com/document/133711/vrf-configuration-and-verification-nexus-7000

NEW QUESTION 8
You have a Cisco UCS system. You need to create VSAN 100 on a Cisco MDS 9000 Series switch and to enable switch port fc 1/10 as a member for the VSAN. Which command set should you use?

• A. Option A
• B. Option B
• C. Option C
• D. Option D

Answer: C

NEW QUESTION 9
Which two benefits come from using a Cisco Nexus 7000 Series Switch in VDC mode? (Choose two )

• A. par-VDC kernel resource allocation
• B. per-VDC administration
• C. per-VDC load balancing for Cisco Ether Channel
• D. per-VDC forwarding information base
• E. per-VDC fault isolation

Answer: BE

NEW QUESTION 10
By default, which action does a bridge domain take with unknown unicast packets?

• A. It forwards the packets to the next 1EP
• B. It floods the packets
• C. It forwards the packets to the gateway
• D. It forwards the packets to the spine proxy

Answer: B

NEW QUESTION 11
Drag and drop the actions on the left to the corresponding scripting tools on the right.

• A. Mastered
• B. Not Mastered

Answer: A

Explanation:

NEW QUESTION 12
Which statement about POAP licensing correctly describes temporary licensing?

• A. Temporary licensing is invoked by using the license grace-period command
• B. Temporary licensing is enabled automatically and is valid for 60 days
• C. Temporary licensing is invoked by using the license Install command
• D. Temporary licensing is enabled automatically and is valid for 30 days

Answer: A

NEW QUESTION 13
What must be configured to allow SNMP traffic on ACl switches?

• A. an out-of-band contract
• B. an out-of-band management interface
• C. SNMP relay Policy
• D. an out-of-band bridge domain

Answer: A

NEW QUESTION 14
You must apply a contract to all of the EPGs in a tenant. The solution must ensure that the contract is also applied to any new EPGs that are added to the tenant. Which option must you uses?

• A. the QUI
• B. the vzAny managed object
• C. the REST API
• D. a Python script

Answer: B

NEW QUESTION 15
Which action must you take to implement VXLAN in an environment that runs the Cisco Nexus 1000V Essential edition?

• A. Purchase and install a Cisco Nexus 1000V Advanced edition license
• B. Enable the feature by using the feature segmentation command
• C. Enable the feature by using the feature vxlan-gateway command
• D. Purchase and install a Cisco Nexus 1000V Enterprise edition license

Answer: B

NEW QUESTION 16
Refer to the exhibit :

You define the port profiles as shown in the exhibit, and then you assign the P10GIG port profile to interface el" Which option is the result of this configuration?

• A. The speed of the interface is 10 Gbps
• B. The speed of the interface is 1 Gbps
• C. The interface uses the maximum speed available for the physical interface.
• D. The speed of the interface is 100 GbpS

Answer: A

NEW QUESTION 17
You are troubleshooting node discovery issues by using the acidiag fnvread command. Which description of the node status when the CLI output shows a status of Discovering is true?

• A. The node is decommissioned
• B. The node ID is configured, but not discovered yet
• C. The node is discovered, but an IP address is not assigned yet
• D. The node is discovered, but the node ID policy is not configured yet

Answer: C

NEW QUESTION 18
You are performing VMM integration between ACI and VMware with vDS. You place a Cisco UCS Fabric Interconnect between the leaf and the ESXi hosts running on UCSB series Which is a valid configuration if using VMM integration with "On Demand" resolution?

• A. In the interface policy group, disable LLDP, enable Cisco Discovery Protocol, and then select MAC pinning on the Fabric Interconnects
• B. In the interface policy, enable LLD
• C. Cisco Discovery Protocol, and LACP
• D. In the interface pokey group, disable LLDP, disable Cisco Discovery Protocol, and then select active in the LACP pokey
• E. Configure LLD
• F. Cisco Discovery Protocol, and LACP policies under global policies to match the interface policies

Answer: A

NEW QUESTION 19
Refer to the exhibit.

You attempt to configure a local SPAN session on a Cisco Nexus 1000V Series Switch by using the vEthernet interface of VM1 as the source port and the vEthernet destination port.
Which description of what happens to the SPAN session is true?

• A. It can be successfully only logged to a file on VEM1.
• B. It secceeds.
• C. Both VMs must be on same VLAN for this work.
• D. It fails.

Answer: D

NEW QUESTION 20
You have a contract between in-band and out-of-band EPGs. Which two descriptions of this contention are true? (Choose two )

• A. Filters apply m the incoming direction only
• B. Both EPGs must be m one VRF
• C. Management statistics are available
• D. Shared services for CPU-bound traffic are supported
• E. The configuration supports Layer 2

Answer: AB

NEW QUESTION 21
You want to modify a service profile that is bound to an updating template. Which description of the relationship between the service profile and the updating template is true?

• A. The service profile is updated after the server reboots.
• B. The service profile is updated automatically when the updating template changes.
• C. Changes to the updating template apply only to service profiles created after template is updated.
• D. The updating template can be changed only before the service profile is implemented

Answer: B

Explanation:
https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/ucs-manager/GUI-User-Guides/Server-Mgmt/3-1

NEW QUESTION 22
Which Cisco APlC health score will be affected if an EPG does not have a Bridge Domain associated with it ?

• A. spine health
• B. leaf health
• C. tenant health
• D. pod health

Answer: C

Explanation:
http://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/1-x/Operating_ACI
/guide/b_Cisco_Operating_ACI/b_Cisco_Operating_ACI_chapter_01010.pdf

NEW QUESTION 23
Which two method does a Cisco APIC supports to connect to the management IP address of a service appliance? (Choose two.)

• A. out-of-band connectivity to devices in device clusters by using the management VLAN D in band connectivity to devices in device clusters by using the VRF of the tenant
• B. out-of-band connectivity to devices m device clusters by using the VRF of the tenant
• C. out-of-band connectivity to devices m device clusters by using the management VRF of the tenant
• D. in band connectivity to devices m device clusters by using the management VRF of the tenant

Answer: AB

NEW QUESTION 24
Which statement accurately describes Cisco ACI flooding mode for unknown unicast traffic?

• A. By default unknown unicast traffic floods the bridge domain
• B. By default, all unknown unicast traffic is dropped
• C. A hardware proxy must be used for flooding mode
• D. By default, an unknown unicast traffic is sent to the spine proxy

Answer: D

NEW QUESTION 25
......