Q1. A network design engineer has been asked to reduce the size of the SPT on an IS-IS broadcast network. Which option should the engineer recommend to accomplish this task? 

A. Configure the links as point-to-multipoint. 

B. Configure QoS in all links. 

C. Configure a new NET address. 

D. Configure the links as point-to-point. 

View Answer

Q2. Which technology allows multiple instances of a routing table to coexist on the same router simultaneously? 

A. VRF 

B. Cisco virtual router 

C. instanced virtual router 

D. IS-IS 

View Answer

Q3. What three benefits exist when utilizing Cisco Nexus technology for implementing a unified fabric design? (Choose three.) 

A. reduced cabling 

B. fewer adapters 

C. consolidated switching 

D. increased bandwidth 

E. enhanced redundancy 

F. improved convergence 

View Answer

Q4. Which of the following facts must be considered when designing for IP telephony within an Enterprise Campus network? 

A. Because the IP phone is a three-port switch, IP telephony extends the network edge, impacting the Distribution layer. 

B. Video and voice are alike in being bursty and bandwidth intensive, and thus impose requirements to be lossless, and have minimized delay and jitter. 

C. IP phones have no voice and data VLAN separation, so security policies must be based on upper layer traffic characteristics. 

D. Though multi-VLAN access ports are set to dot1q and carry more than two VLANs they are not trunk ports. 

View Answer

Q5. Which route summarization most efficiently reduces perceived network complexity that is composed of subnetworks ranging from 172.16.20.0/24 to 172.16.36.0/24? 

A. 172.16.8.0/21 

B. 172.16.8.0/19 

C. 172.16.20.0/20 

D. 172.16.0.0/18 

E. 172.16.20.0/19 

View Answer

Q6. Which network virtualization plane is used to separate traffic forwarding tables? 

A. control 

B. data 

C. management 

D. access 

View Answer

Q7. Which statement about vPC technology is true? 

A. It allows a device to connect to two separate upstream devices as if they were a single device. 

B. It provides the ability to pair two servers in the data center. 

C. It promotes better STP designs in the switching infrastructure. 

D. It supports IEEE 802.1Q only. 

View Answer

Q8. A network engineer must perform posture assessments on Cisco ASA remote access VPN clients and control their network access based on the results. What mode is the Cisco best practice NAC deployment design for this situation? 

A. Layer 2 in-band real IP gateway mode 

B. Layer 2 out-of-band real IP gateway mode 

C. Layer 3 in-band virtual gateway mode 

D. Layer 3 out-of-band virtual gateway mode 

View Answer

Q9. An organization is designing the IP allocation of a new site. It currently has 12 separate IP 

segments. Each segment must be /24, accommodate 25% of growth, and be easily summarized. 

Which summarized IP block can be subnetted to meet these requirements? 

A. /18 

B. /19 

C. /20 

D. /21 

View Answer

Q10. A network engineer must create a Layer 2 switch block design that has deterministic convergence and is loop-free at Layer 2. Which two switch block elements are needed to meet the requirements? (Choose two.) 

A. Layer 3 link between distribution switches 

B. HSRP with interface tracking on uplinks to core switches 

C. RPVST with equal bridge priority on distribution switches 

D. VLANs that do not span access switches 

E. Layer 2 link between distribution switches 

View Answer