Q1. A network engineer wants to enable a FCoE feature on a Cisco Nexus 5500 Series Switch. When does that occur? 

A. after the configuration is saved and rebooted 

B. after the configuration is saved 

C. after at least one port is configured to operate in FCoE mode 

D. after the license is applied 

View Answer

Q2. On the Cisco Nexus 5000, which three commands help verify network connectivity? (Choose three.) 

A. ping 

B. show interface brief 

C. show otv 

D. show vdc membership 

E. traceroute 

View Answer

Q3. Which three are features of Cisco OTV? (Choose three.) 

A. control plane-based MAC learning 

B. dynamic encapsulation 

C. MAC address learning based on flooding 

D. pseudo wires and tunnels 

E. complex dual-homing 

F. native automated multihoming 

View Answer

Q4. What are the three basic states of an Ethernet interface on a Cisco Unified Computing 

System Fabric Interconnect? (Choose three.) 

A. unconfigured 

B. enabled 

C. disabled 

D. uplink 

E. server 

F. errdisabled 

View Answer

Q5. Refer to the exhibit. 

After you install and configure a Cisco Nexus 5548, you notice that you cannot ping its default gateway. Assume that your management interface is up and running, and other devices in the same subnet or VLAN can communicate with the default gateway. 

Which statement describes the problem? 

A. The subnet of the management port is incorrect. 

B. The default route is configured incorrectly. 

C. You are using the incorrect cable. 

D. You must ping from the management VRF. 

View Answer

Q6. Which feature monitors state transitions of components and processes in Cisco Unified Computing System? 

A. finite state machine 

B. state monitor 

C. state manager 

D. discovery 

E. logical state arbiter 

View Answer

Q7. A storage engineer has a new requirement to have control plane and data plane separation between the financing and student storage pools. What SAN technology can be used to facilitate this? 

A. Zones 

B. Zone Sets 

C. VSANs 

D. Port Security 

E. VLANs 

View Answer

Q8. Which is a key characteristic of virtual device contexts? 

A. allowing logical switches to be aggregated into a single physical switch 

B. allowing logical switches to be aggregated into multiple physical switches 

C. allowing physical switches to be partitioned to a single virtual switch 

D. allowing physical switches to be partitioned to multiple virtual switches 

View Answer

Q9. Refer to the exhibit. A network engineer proposes a hierarchical network design for building a company's campus network as shown. What are three advantages of this approach? (Choose three.) 

A. offers a hierarchy in which all layers share similar roles 

B. offers a hierarchy in which each layer has a specific role 

C. offers a modular topology with segregated building blocks 

D. offers a flat topology with integrated building blocks 

E. promotes a network virtualization traffic pattern 

F. creates small fault domains with clear demarcations and isolation 

View Answer

Q10. OTSPOT 

View Answer