Q1. When configuring an H.323 gateway, which configuration option can be used to set whether an incoming call is considered off the network (OffNet) or on the network (OnNet)?
A. call classification
B. call location
C. device pool
D. signaling port
Answer: A
Q2. You are a Voice Engineer at ABC Company. You want to provision a new voice gateway for a remotesite, and you need to configure 24 channels of a T1 CAS interface. Which set is the correct set ofcommands for this configuration?
A. R1(config)# controller t1 1/0
R1(config-controller)# framing esf
R1(config-controller)# linecode b8zs
R1(config-controller)# primary-group 1 timeslot 1-24 type fxo-loop-start
B. R1(config)# controller t1 1/0
R1(config-controller)# linecode hdb3
R1(config-controller)# framing crc4
R1(config-controller)# clock source line
R1(config-controller)# ds0-group 1 timeslot 1-24 type fxo-loop-start
C. R1(config)# isdn switch-type primary-5ess
R1(config)# controller t1 t1/0
R1(config-controller)# pri-group timeslots 1-24
D. R1(config)# controller t1 1/0
R1(config-controller)# framing esf
R1(config-controller)# linecode b8zs
R1(config-controller)# clock source line
R1(config-controller)# ds0-group 1 timeslot 1-24 type fxo-loop-start
Answer: D
Explanation: Reference:
Page 9-11 http://www.cisco.com/c/en/us/td/docs/ios/voice/isdn/configuration/guide/12_4t/vi_12_4t_bo ok/
vi_imp_t1cas_voip.pdf
Q3. Which discard digits instruction removes all digits prior to the North American Numbering Plan portion of the route pattern?
A. PreDot
B. PreAt
C. Pre
D. PreNANP
Answer: B
Q4. Refer to Exhibit:
If the user at extension 1001 dials the user at extension 2001, which dial peer is used to route the call?
A. 3
B. 2
C. 4
D. 1
Answer: C
Q5. Which three steps must you take on Cisco Unified Communications Manager to configure
Cisco TelePresence Conductor for ad hoc and rendezvous conferences? (Choose three.)
A. Verify the location configuration.
B. Verify the certificate trusts.
C. Configure one ICT trunk to TelePresence Conductor.
D. Configure one SIP trunk to TelePresence Conductor.
E. Configure two ICT trunks to TelePresence Conductor.
F. Configure two SIP trunks to TelePresence Conductor.
Answer: A,B,F
Q6. Which option describes how you add software conference bridges to Cisco Unified CommunicationsManager?
A. By adding a Cisco Unified CM server to the cluster.
B. By adding a software conference bridge using Conference Bridge Configuration.
C. By installing DSP to a Cisco Unified CM server.
D. By reassigning other media resources to conference resources.
Answer: A
Q7. ABC SA de CV is a Company located in New York City and has 3 Branch Offices in Laredo, Bryan, and Houston Texas. The network Administrator has the requirement to configure that all international calls goes out first for Houston Texas, if the GW of Houston goes down then the international call goes out for Bryan Texas and if GW of Bryan goes down, the international call will go out of Laredo Texas. What does the Administrator have to configure to achieve this requirement?
A. Configure a Route Pattern selecting all possible gateways.
B. Configure a Line Group for international calls selecting the first option GW of Houston, then Bryan and finally Laredo. After this he has to configure a Hunt List for international calls selecting the Line Group for international calls and finally create the Hunt Pilot for International calls selecting the Hunt List created for international calls.
C. Configure a New Partition and New CSS for international calls.
D. Configure a Route Group for international calls selecting the first option GW of Houston, then Bryan and finally Laredo. After this he has to configure a Route List for international calls selecting the Route Group for international calls and finally create the Route Pattern for International calls selecting the Route List created for international calls.
Answer: D
Explanation: Reference:
Page 187
CIPTV110SG_Vol1
Q8. What is a VoIP dial peer?
A. A nonaddressable call endpoint.
B. A call routing mechanism to send and receive calls based on called or calling digits.
C. A physical connection for call legs.
D. A logical connection for call legs.
Answer: B
Q9. Which dial plan function is used to restrict calls that are made by a lobby phone to internal extensionsonly?
A. Path selection.
B. Endpoint addressing.
C. Manipulation of dialed destination.
D. Calling privileges.
Answer: D
Q10. Which three configuration options are currently unsupported when configuring the Cisco UnifiedBorder Element for videoconferencing? (Choose three)
A. RSVP synchronization of H.323 calls.
B. Multiple logical channels per call leg.
C. H.323-to-SIP video traffic.
D. FECC support.
E. Video endpoints with different H.245 versions.
F. Dual video/picture-in-picture.
G. DSCP marking for video streams.
Answer: C,E,F
Explanation: Reference:
http://www.cisco.com/c/en/us/td/docs/ios/voice/cube/configuration/guide/15_2/vb_gw_15_2_book/vb-gwvideo.