Q1. Refer to the exhibit. 

If an IP phone in San Jose roams to New York, which two IP phone settings will be modified by Device Mobility so that the phone can place and receive calls in New York? (Choose two.) 

A. The physical locations are not different, so the configuration of the phone is not modified. 

B. The physical locations are different, so the roaming-sensitive parameters of the roaming device pool are applied. 

C. The device mobility groups are the same, so the Device Mobility-related settings are applied in addition to the roaming-sensitive parameters. 

D. The Device Mobility information is associated with one or more device pools other than the home device pool of the phone, so one of the associated device pools is chosen based on a round-robin load-sharing algorithm. 

E. The Device Mobility information is associated with the home device pool of the phone, so the phone is considered to be in its home location. Device Mobility will reconfigure the roaming-sensitive settings of the phone. 

View Answer

Q2. Which option is a benefit of implementing CFUR? 

A. CFUR is designed to initiate TEHO to reduce toll charges. 

B. CFUR can prevent phones from unregistering. 

C. CFUR can reroute calls placed to a temporarily unregistered destination phone. 

D. CFUR eliminates the need for COR on an ISR. 

View Answer

Q3. Refer to the exhibit. 

The HQ site uses area code 650. The BR1 site uses area code 408. The long distance national code for PSTN dialing is 1. To make a long distance national call, an HQ or BR1 user dials access code 9, followed by 1, and then the 10-digit number. Both sites use MGCP gateways. AAR must use globalized call routing using a single route pattern. Assume that all outgoing PSTN numbers are localized at the egress gateway as shown in the exhibit. 

What should the AAR group prefix be? 

A. 9 

B. 91 

C. none 

D. + 

E. +1 

View Answer

Q4. Which E.164 transformation pattern represents phone numbers in Germany? 

A. \+49.! 

B. 49.! 

C. \49.! 

D. \+49.X 

View Answer

Q5. The relationship between a Region and a Location is that the Region codec parameter is used between a Region and its configured Locations. 

A. TRUE 

B. FALSE 

View Answer

Q6. Which Cisco IOS command is used to verify that the Cisco Unified Communications Manager Express has registered with the SAF Forwarder? 

A. show eigrp service-family ipv4 clients 

B. show eigrp address-family ipv4 clients 

C. show voice saf dndb all 

D. show saf registration 

E. show ip saf registration 

View Answer

Q7. When device mobility mode is enabled or disabled for a cluster, to which does the cluster setting apply? 

A. all phones in the cluster that support device mobility 

B. all phones in the cluster that subscribed to device mobility 

C. mobile phones in the cluster that support device mobility 

D. mobile phones in the cluster that are in default mode 

View Answer

Q8. For which VoIP protocol does a gatekeeper provide address translation and control access? 

A. H.323 

B. SIP 

C. Skinny 

D. H.248 

View Answer

Q9. What is the purpose of a SAF Client? 

A. To decode address information and route calls to and from the end points 

B. To pass IP information from the CUCM to the endpoint 

C. To learn about and advertise or subscribe information about SAF network services 

D. To reside in the Cisco IOS software, and to communicate with the SAF forwarder 

View Answer

Q10. Which system configuration is used to set a restriction on audio bandwidth? 

A. region 

B. location 

C. physical location 

D. licensing 

View Answer