NEW QUESTION 1

Which two types of connections can be used to build data center interconnects via vPC? (Choose two)

• A. company-owned DWDM
• B. service providers MPLS
• C. service provider IP
• D. service provider DWDM
• E. service provider VPLS

Answer: AD

NEW QUESTION 2

Which type of switch interfaces are supported in classic NPV mode for a Fibre Channel network?

• A. the vFC internal port and the physical external port
• B. the physical internal port and the physical external port
• C. the vFC internal port and the vFC external port
• D. the vFC external port and the physical internal port

Answer: D

NEW QUESTION 3

Which two STP port types are available in Cisco NX-OS? (Choose two.)

• A. normal
• B. edge
• C. blocked
• D. root
• E. point-to-point

Answer: AB

Explanation:
http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/nx-os/layer2/configuration/guide/b_Cisco_Nexus_
You can configure a spanning tree port as an edge port, a network port, or a normal port. A port can be in only one of these states at a given time. The default spanning tree port type is normal. Edge ports, which are connected to Layer 2 hosts, can be either an access port or a trunk port

NEW QUESTION 4

Which two terms relate to the capability of a physical NIC to present virtual NICs to the operating system or hypervisor? (Choose two.)

• A. VM-FEX
• B. NPIV
• C. Adapter-FEX
• D. NIV
• E. host vPC
• F. NIC teaming

Answer: CD

NEW QUESTION 5

When deploying VMWare ESXi on Cisco UCS B Series Servers, what should the iSCSI boot-from-SAN use in the service profile to provide redundancy?

• A. two VMKs to connect to the storage
• B. two vHBAs to connect to the storage
• C. two vnmics to connect to the storage
• D. two vNICs to connect to the storage

Answer: B

NEW QUESTION 6

Which two statements accurately describe a Cisco UCS Fabric Interconnect cluster? (Choose two )

• A. Only the active Fabric Interconnect forwards data traffic
• B. The Fabric Interconnect cluster uses a Cisco UCS B-Senes Blade Server chassis to forward data when the L1-L2 links are down
• C. The Fabric Interconnect cluster uses a virtual IP address for management connections
• D. The Fabric Interconnect uses L1-L2 links to forward data when the primary Fabric Interconnect uplinks are down.
• E. primary Fabric Inter connect node conies up after a failure, the node compares the Cisco UCS systemdatabase version to Fabric Interconnect

Answer: CE

NEW QUESTION 7

The classical aggregation layer design does not provide isolation on the control plane and on the data plane. What is the solution to this problem?

• A. STP
• B. VDC
• C. Cisco ISO ISSU
• D. HSRP

Answer: B

NEW QUESTION 8

Which component is required to run FCoE?

• A. converged network adapter
• B. iSCSI gateway
• C. host bus adapter
• D. Fibre Channel adapter

Answer: A

Explanation:
Computers can connect to FCoE with converged network adapters (CNAs), which contain both Fibre Channel host bus adapter (HBA) and Ethernet Network Interface Card (NIC) functionality on the same adapter card. CNAs have one or more physical Ethernet ports. FCoE encapsulation can be done in software with a conventional Ethernet network interface card, however FCoE CNAs offload (from the CPU) the low level frame processing and SCSI protocol functions traditionally performed by Fibre Channel host bus adapters.

NEW QUESTION 9

Why would you configure FCoE to use jumbo frames?

• A. to enable the network to create a no-drop CoS
• B. to provide a credit-based flow control mechanism
• C. to prevent a Fibre Channel frame from being split into two Ethernet frames
• D. to provide prioritized processing that is based on bandwidth allocation and low latency

Answer: B

NEW QUESTION 10

You plan to extend the Layer 2 domain by using OTV in multicast mode What must you consider?

• A. The same site ID must be used on all of the edge devices on all of the sites.
• B. The join interface must run IGMPv3
• C. The OTV site VLAN must be extended over the overlay.
• D. The site OTV VLAN must be the same on all of the AED routers on all of the sites.

Answer: B

NEW QUESTION 11

Which statement accurately describes VSAN-based QoS when the same flow is present in two class maps that are associated to a policy map?

• A. The highest QoS value is used.
• B. The lowest QoS value is used.
• C. The QoS value of the class map that is attached first takes effect.
• D. The QoS value of the class map that is attached last takes effect.

Answer: C

Explanation:
http://www.cisco.com/en/US/products/ps5989/products_configuration_guide_chapter09186a0080663141.html

NEW QUESTION 12

You are configuring CIMC management IP pools. You need to avoid the following misconfigurations: Assigning an IP pool that contains only IPv4 addresses as the in-band IPv6 policy
Assigning an IP pool that contains only IPv6 addresses as the in-band IPv4 policy to a server CIMC What does a cisco recommend?

• A. Configure two separate in-band addresses pools that each have only IPv4 or IPv6 addresses
• B. Configure out-of-band management only for IPv6 and accept the default settings for IPv4
• C. Accept the default pool settings for both IPv4 and IPv6
• D. Configure out-of-band management only for IPv4 and accept the default settings for IPv6

Answer: A

NEW QUESTION 13

Which solution enables you to scale up an IPS by load-balancing traffic to servers or appliances?

• A. Cisco ITD
• B. Cisco AMP
• C. Cisco ASA with FirePOWER Services
• D. PBR

Answer: A

NEW QUESTION 14

You must design a Cisco UCS Manager service profile for a customer. They require that the Cisco UCS blades utilize Cisco Discovery Protocol. Which policy must you add to the service profile template to meet this requirement?

• A. network control policies
• B. link protocol policies
• C. LAN connectivity policies
• D. flow control policies

Answer: A

NEW QUESTION 15

Which two actions must be performed when you configure Cisco VN-Link in hardware? (Choose two.)

• A. Create a distributed virtual switch in Cisco UCS Manager.
• B. Add an ESX host to the distributed virtual switch in Cisco UCS Manager.
• C. Create a port profile and profile clients in Cisco UCS Manager.
• D. Create a standard switch on an ESXi host and map the network adapters to the switch.
• E. Create a distributed virtual switch under the datacenter folder in VMware vCenter.

Answer: AC

NEW QUESTION 16

Which statement regarding network management for the data center is true?

• A. Flexible NetFlow can be used to provide enhanced network anomaly and security detection.
• B. The Network Analysis Module is best deployed in the core for highest visibility.
• C. NetFlow Support is available on most IOS and Nexus products, excluding the Nexus 1000v
• D. NetFlow Data Export is best positioned on the Nexus 5500 at the access or aggregation layer.

Answer: A

NEW QUESTION 17

Which two platforms support the FCoE protocol? (Choose two)

• A. Cisco MDS 9148S Series
• B. Cisco MDS 9222i series
• C. Cisco Nexus 2332TQ Series
• D. Cisco nexus 7010 series
• E. Cisco Nexus 2248TP series

Answer: CD

NEW QUESTION 18

Which two storage technologies can be integrated into the Cisco ACI fabric? (Choose two)

• A. FCIP
• B. DAS
• C. iSCSI
• D. NAS
• E. FC

Answer: CE

NEW QUESTION 19

Which two options are valid methods for configuring VLANs on a Cisco UCS cluster? (Choose two.)

• A. globally per Cisco UCS cluster
• B. by using Cisco UCS Fabric Interconnect
• C. by using vPC domain configuration
• D. by using VTP
• E. by using CFS

Answer: AB

Explanation:
http://www.cisco.com/c/en/us/support/docs/servers-unified-computing/ucs-2104xp-fabric-extender/110517-vlan

NEW QUESTION 20

Which two options are supported on Cisco UCS Fabric Interconnects that use native Fibre Channel connectivity? (Choose two)

• A. iSCSI
• B. NFS
• C. DAS
• D. SAN
• E. iFCP

Answer: CD

NEW QUESTION 21

You plan to configure OTV multicast. What must you enable to use SSM?

• A. IGMFv3
• B. PIM-DM
• C. IGMPv2
• D. PIM-SM
• E. PIM Anycast-RP

Answer: D

NEW QUESTION 22
......