Q1. Refer to the exhibit.

How can the traffic that is mirrored out the GigabitEthernet0/48 port be limited to only traffic that is received or transmitted in VLAN 10 on the GigabitEthernet0/1 port?

A. Change the configuration for GigabitEthernet0/48 so that it is a member of VLAN 10.

B. Add an access list to GigabitEthernet0/48 to filter out traffic that is not in VLAN 10.

C. Apply the monitor session filter globally to allow only traffic from VLAN 10.

D. Change the monitor session source to VLAN 10 instead of the physical interface.

View Answer

Q2. Which authentication service is needed to configure 802.1x?

A. RADIUS with EAP Extension

B. TACACS+

C. RADIUS with CoA

D. RADIUS using VSA

View Answer

Q3. The command storm-control broadcast level 75 65 is configured under the switch port connected to the corporate mail server. In which three ways does this command impact the traffic? (Choose three.)

A. SNMP traps are sent by default when broadcast traffic reaches 65% of the lower-level threshold.

B. The switchport is disabled when unicast traffic reaches 75% of the total interface bandwidth.

C. The switch resumes forwarding broadcasts when they are below 65% of bandwidth.

D. Only broadcast traffic is limited by this particular storm control configuration.

E. Multicast traffic is dropped at 65% and broadcast traffic is dropped at 75% of the total interface bandwidth.

F. The switch drops broadcasts when they reach 75% of bandwidth.

View Answer

Q4. A network engineer is installing a switch for temporary workers to connect to. The engineer does not want this switch participating in Spanning Tree with the rest of the network; however, end user connectivity is still required. Which spanning-tree feature accomplishes this?

A. BPDUblock

B. BPDUfilter

C. BPDUignore

D. BPDUguard

E. BPDUdisable

View Answer

Q5. A network engineer is setting up a new switched network. The network is expected to grow and add many new VLANs in the future. Which Spanning Tree Protocol should be used to reduce switch resources and managerial burdens that are associated with multiple spanning-tree instances?

A. RSTP

B. PVST

C. MST

D. PVST+

E. RPVST+

View Answer

Q6. Which private VLAN can have only one VLAN and be a secondary VLAN that carries unidirectional traffic upstream from the hosts toward the promiscuous ports and the gateway?

A. isolated VLAN

B. primary VLAN

C. community VLAN

D. promiscuous VLAN

View Answer

Q7. Which portion of AAA looks at what a user has access to?

A. authorization

B. authentication

C. accounting

D. auditing

View Answer

Q8. Refer to the exhibit.

The network switches for two companies have been connected and manually configured for the required VLANs, but users in company A are not able to access network resources in company B when DTP is enabled. Which action resolves this problem?

A. Delete vlan.dat and ensure that the switch with lowest MAC address is the VTP server.

B. Disable DTP and document the VTP domain mismatch.

C. Manually force trunking with switchport mode trunk on both switches.

D. Enable the company B switch with the vtp mode server command.

View Answer

Q9. What is required for a LAN switch to support 802.1q Q-in-Q encapsulation?

A. Support less than 1500 MTU

B. Support 1504 MTU or higher

C. Support 1522 layer 3 IP and IPX packet

D. Support 1547 MTU only

View Answer

Q10. after configuring new data VLANs 1020 through 1030 on the VTP server, a network engineer notices that none of the VTP clients are receiving the updates. What is the problem?

A. The VTP server must be reloaded.

B. The VTP version number must be set to version 3.

C. After each update to the VTP server, it takes up to 4 hours propagate.

D. VTP must be stopped and restarted on the server.

E. Another switch in the domain has a higher revision number than the server.

View Answer