New Questions 5

Refer to the exhibit.

Which login credentials are required when connecting to the console port in this output?

A. none required

B. username cisco with password cisco

C. no username with password linepass

D. login authentication default

View Answer

New Questions 6

Ferris Plastics, Inc. is a medium sized company, with an enterprise network (access, distribution and core switches) that provides LAN connectivity from user PCs to corporate servers. The distribution switches are configured to use HSRP to provide a high availability solution.

u2022 DSW1 -primary device for VLAN 101 VLAN 102 and VLAN 105

u2022 DSW2 - primary device for VLAN 103 and VLAN 104

u2022 A failure of GigabitEthemet1/0/1 on primary device should cause the primary device to release its status as the primary device, unless GigabitEthernet1/0/1 on backup device has also failed.

Troubleshooting has identified several issues. Currently all interfaces are up. Using the running configurations and show commands, you have been asked to investigate and respond to the following question.

What is the priority value of the VLAN 105 HSRP group on DSW2?

A. 50

B. 100

C. 150

D. 200

View Answer

New Questions 7

To follow the Layer 2 switching guidelines, a network engineer decides to create a separate spanning tree for every group of 10 VLANs. Which version of spanning tree is appropriate to meet the company policy?

A. MST

B. PVST+

C. RSTP

D. RPVST+

E. STP

View Answer

New Questions 8

Regarding high availability, with the MAC address 0000.0c07.ac03, what does the u201c03u201d represent?

A. The GLBP group number

B. The type of encapsulation

C. The HSRP router number

D. The VRRP group number

E. The HSRP group number

F. The active router number

View Answer

New Questions 9

A network engineer changed the port speed and duplex setting of an existing EtherChannel bundle that uses the PAgP protocol. Which statement describes what happens to all ports in the bundle?

A. PAgP changes the port speed and duplex for all ports in the bundle.

B. PAgP drops the ports that do not match the configuration.

C. PAgP does not change the port speed and duplex for all ports in the bundle until the switch is rebooted.

D. PAgP changes the port speed but not the duplex for all ports in the bundle.

View Answer

New Questions 10

Which statement about the use of PAgP link aggregation on a Cisco switch that is running Cisco IOS Software is true?

A. PAgP modes are off, auto, desirable, and on. Only the combinations auto-desirable, desirable-desirable, and on-on allow the formation of a channel.

B. PAgP modes are active, desirable, and on. Only the combinations active-desirable, desirable-desirable, and on-on allow the formation of a channel.

C. PAgP modes are active, desirable, and on. Only the combinations active-active, desirable-desirable, and on-on allow the formation of a channel.

D. PAgP modes are off, active, desirable, and on. Only the combinations auto-auto, desirable-desirable, and on-on allow the formation of a channel.

View Answer

New Questions 11

Which statement about the MAC address sticky entries in the switch when the copy run start command is entered is true?

A. A sticky MAC address is retained when the switch reboots.

B. A sticky MAC address can be a unicast or multicast address.

C. A sticky MAC address is lost when the switch reboots.

D. A sticky MAC address ages out of the MAC address table after 600 seconds.

View Answer

New Questions 12

Ferris Plastics, Inc. is a medium sized company, with an enterprise network (access, distribution and core switches) that provides LAN connectivity from user PCs to corporate servers. The distribution switches are configured to use HSRP to provide a high availability solution.

u2022 DSW1 -primary device for VLAN 101 VLAN 102 and VLAN 105

u2022 DSW2 - primary device for VLAN 103 and VLAN 104

u2022 A failure of GigabitEthemet1/0/1 on primary device should cause the primary device to release its status as the primary device, unless GigabitEthernet1/0/1 on backup device has also failed.

Troubleshooting has identified several issues. Currently all interfaces are up. Using the running configurations and show commands, you have been asked to investigate and respond to the following question.

During routine maintenance, it became necessary to shut down the GigabitEthernet1/0/1 interface on DSW1 and DSW2. All other interfaces were up. During this time, DSW1 became the active router for the VLAN 104HSRP group. As related to the VLAN 104HSRP group, what can to be done to make the group function properly?

A. On DSW1, disable preempt.

B. On DSW2 decrease the priority value to a value less than 150.

C. On DSW1, increase the decrement value in the track command to a value greater than 6.

D. On DSW1, decrease the decrement value in the track command to a value less than 1.

View Answer

New Questions 13

What effect does the mac address-table aging-time 180 command have on the MAC address-table?

A. This is how long a dynamic MAC address will remain in the CAM table.

B. The MAC address-table will be flushed every 3 minutes.

C. The default timeout period will be 360 seconds.

D. ARP requests will be processed less frequently by the switch.

E. The MAC address-table will hold addresses 180 seconds longer than the default of 10 minutes.

View Answer

New Questions 14

Which command creates a login authentication method named "login" that will primarily use RADIUS and fail over to the local user database?

A. (config)# aaa authentication login default radius local

B. (config)# aaa authentication login login radius local

C. (config)# aaa authentication login default local radius

D. (config)# aaa authentication login radius local

View Answer

New Questions 15

Refer to the exhibit.

An engineer has run the show EtherChannel summary command and the output is displayed. Which statement about the status of the EtherChannel is true?

A. The EthcrChannel is operational and configured for PAgP

B. The EttherChannel is down because of a mismatched EtherChannel protocol

C. The EttherChannel is down and configured for LACP

D. The EttherChannel is operational and is usig no EtherChannel protocol

View Answer