Q1. When you design a switched network using VTPv2, how many VLANs can be used to carry user traffic?

A. 1000

B. 1001

C. 1024

D. 2048

E. 4095

F. 4096

View Answer

Q2. Refer to the exhibit.

A network engineer wants to analyze all incoming and outgoing packets for an interface that is connected to an access switch. Which three items must be configured to mirror traffic to a packet sniffer that is connected to the distribution switch? (Choose three.)

A. A monitor session on the distribution switch with a physical interface as the source and the remote SPAN VLAN as the destination

B. A remote SPAN VLAN on the distribution and access layer switch

C. A monitor session on the access switch with a physical interface source and the remote SPAN VLAN as the destination

D. A monitor session on the distribution switch with a remote SPAN VLAN as the source and physical interface as the destination

E. A monitor session on the access switch with a remote SPAN VLAN source and the physical interface as the destination

F. A monitor session on the distribution switch with a physical interface as the source and a physical interface as the destination

View Answer

Q3. A network engineer must set the load balance method on an existing port channel. Which action must be done to apply a new load balancing method?

A. Configure the new load balancing method using port-channel load-balance.

B. Adjust the switch SDM back to "default".

C. Ensure that IP CEF is enabled globally to support all load balancing methods.

D. Upgrade the PFC to support the latest load balancing methods.

View Answer

Q4. Which technique allows specific VLANs to be strictly permitted by the administrator?

A. VTP pruning

B. transparent bridging

C. trunk allowed VLANs

D. VLAN access-list

E. L2P tunneling

View Answer

Q5. While troubleshooting a network outage, a network engineer discovered an unusually high level of broadcast traffic coming from one of the switch interfaces. Which option decreases consumption of bandwidth used by broadcast traffic?

A. storm control

B. SDM routing

C. Cisco IOS parser

D. integrated routing and bridging

E. Dynamic ARP Inspection

View Answer

Q6. Which VLAN range is eligible to be pruned when a network engineer enables VTP pruning on a switch?

A. VLANs 1-1001

B. VLANs 1-4094

C. VLANs 2-1001

D. VLANs 2-4094

View Answer

Q7. Refer to the exhibit.

What is the result of the configuration?

A. The EtherChannels would not form because the load-balancing method must match on the devices.

B. The EtherChannels would form and function properly even though the load-balancing and EtherChannel modes do not match.

C. The EtherChannels would form, but network loops would occur because the load- balancing methods do not match.

D. The EtherChannels would form and both devices would use the dst-ip load-balancing method because Switch1 is configured with EtherChannel mode active.

View Answer

Q8. What is the maximum number of 10 Gigabit Ethernet connections that can be utilized in an EtherChannel for the virtual switch link?

A. 4

B. 6

C. 8

D. 12

View Answer