Q1. A technician is assigned a task to configure a new server with six hard drives. The senior administrator requested the technician utilize the drives for maximum fault tolerance. Which of the following RAID configurations should the technician use?

A. RAID 3

B. RAID 5

C. RAID 10

D. RAID 0

View Answer

Q2. A number of users are indicating that access to a network file server is responding very slowly when reading or writing to the share. The server administrator notes that a drive has failed in a four-disk RAID 5 array. The array is running in a degraded state because no hot spare was configured. After replacing the failed disk, which of the following steps would be BEST to take to prevent slow response after a drive failure?

A. Add a drive to the array, but do not configure it as a hot spare.

B. Add an additional hard drive, and convert the volume to a RAID 6 configuration.

C. Add an additional hard drive, and convert the volume to a RAID 10 configuration.

D. Add a drive to the array, and configure it as a cold spare.

View Answer

Q3. Which of the following power plug types would MOST likely be found in a medical facility?

A. Tip/Ring/Sleeve

B. Speed lock

C. Tip/Ring

D. Twist lock

View Answer

Q4. While performing routine testing of a hot standby site located at a remote hosting center, a system administrator is unable to access one of the server operating systems to verify functionality. Which of the following is MOST applicable to access the host?

A. KVM over IP

B. RDP over HTTP

C. Secure shell

D. Serial console access

E. VNC

View Answer

Q5. A company is planning to replace old hardware and needs to budget accordingly. Which of the following is likely to contain a list of end of life servers?

A. The server's warranty information.

B. The server's life cycle schedule.

C. The asset management database.

D. The software licensing agreement.

View Answer

Q6. An administrator is asked to change a configuration using a GUI on a Windows server, but does not have access to a KVM. Which of the following is BEST to make the change?

A. SSH

B. SCP

C. RDP

D. NTP

View Answer

Q7. A user is unable to save an image file to their home directory on a server. The server technician checks the disk space and ACL on the user's home directory and finds that the user has enough space and required access to write to the directory. Which of the following is the MOST likely reason why the user is unable to save the file?

A. The user is attempting to save a file with a prohibited file extension.

B. There are too many open files on the server.

C. The user does not have permission to save files to the server.

D. The hard drive containing the user's home directory, is failing.

View Answer

Q8. A system administrator has just performed a backup. Which of the following should the administrator perform to easily identify the backup tape?

A. Label the tape

B. Mount the tape in the drive

C. Place the tape in the rack

D. Update the site log

View Answer

Q9. A technician reads a hardware manufacturer's blog indicating a critical firmware update is available for the company's file server. Which of the following is the BEST course of action?

A. Download and install a firmware update from a centralized server.

B. Download the firmware update and test it on a VM.

C. Download the firmware update and test it on a non-production server.

D. Download the firmware update and run it on the company's file server immediately.

View Answer

Q10. A system administrator is tasked to setup a database server with failover clustering feature

enabled. One of the requirements is to have one database running at all times with data being synchronizedand replicated to the idle database in case the primary database server fails. Both servers will be monitored by a witness on a LUN. Which of the followingcluster techniques should be implemented to meet these requirements?

A. Active/Active

B. Active/Passive

C. Single Local Quorum

D. Passive/Passive

E. Shared Multiple Quorum

View Answer