Q1. An administrator sees a message in the system console that a drive is bad in the single- volume JBOD storage array. A few minutes later, a user calls the help deskto report an inability to read a file from amapped drive.Which of the following should theadministratordo?

A. Swap out the failed drive and let the array rebuild.

B. Allow the array rebuild automatically using the hotspare.

C. Replace the failed drive and restore the data from the last backup.

D. Reseat the failed drive and restore the array using the parity drive.

View Answer

Q2. A system administrator has just performed a backup. Which of the following should the administrator perform to easily identify the backup tape?

A. Label the tape

B. Mount the tape in the drive

C. Place the tape in the rack

D. Update the site log

View Answer

Q3. Anadministrator isbuilding a web server to host an online banking application. Theserver should not have access to the internal network, andonly ports that are used by theapplication should be opened. Whichof the following MUSTbe implemented to meet the business requirements?

A. Add the server to the internal network and use IPSec to encrypt communication between the web server and other devices.

B. Use an ISA server to block access to the internal network.

C. Use VPN to block all ports that are not used by the application.

D. Use the company firewall to block all ports that are not used by the application.

View Answer

Q4. Auserreports thatascript \\Server\Share\Runme.bat, which isrunon a daily basis, cannot be accessed. Which of the following is the FIRST step to take in resolving this issue?

A. Check the network cable.

B. Ping the gateway.

C. Verify the workstation IP address.

D. Ping the server.

View Answer

Q5. A system administrator has determined thatmore storageis needed for company data. The storage requires thehighest speed data transfer rate with maximum performance. Which of the following solutions MUSTbe implemented to meet the business requirements?

A. FC SAN

B. FCoE

C. iSCSI

D. JBOD

View Answer

Q6. A blade server chassis has two power supplies. Which of the following is a benefit of a technician connecting each power supply to a separate UPS unit?

A. Quality of service

B. Fault tolerance

C. Traffic shaping

D. Load balancing

View Answer

Q7. A hardware compatibility list recommends striping with double parity as storage for an application. In a test environment, a technician realizes that a different RAID level can be used to compensate for a limited number of available disks. Which of the following is the closest RAID level the technician should deploy while minimizing the number of disks and maintaining fault tolerance?

A. 0

B. 1

C. 5

D. 10

View Answer

Q8. Users on a network segment report that they are unable to connect to a newly installed file server. The file server IP address settings are as follows:

IP address: 10.0.10.254

Subnet Mask: 255.255.255.0

Default Gateway: 10.10.10.1

Which of the following changes should the server administrator make?

A. Change the IP address on the server to 10.10.0.254.

B. Change the IP address on the server to 10.10.10.254.

C. Change the default gateway on the server to 10.10.10.254.

D. Change the subnet mask on the server to 255.255.0.0.

View Answer

Q9. A technician is concerned about memory data corruption in a server. Which of the following memory types should be considered?

A. Static

B. SDRAM

C. Dynamic

D. ECC

View Answer

Q10. A technician notices a rack mounted server is beeping without booting up. The NEXT step to diagnose this issue would be to:

A. continue to power cycle the server until it boots normally.

B. count the beeps and reference the service manual.

C. disable the alarm within the server.

D. install the server into a different rack.

View Answer