P.S. Download 200-125 pack are available on Google Drive, GET MORE: https://drive.google.com/open?id=1kYtwvDfK3CIMnjUzKdkde8F69Zg0NhM8
New Questions 15
A router has learned three possible routes that could be used to reach a destination network One route is from EIGRP and has a composite metric of 07104371. Another route is from OSPF with a metric of 782 The last is from RIPv2 and has a metric of 4 Which route or routes will the router install in the routing table?
A. the EIGRP route
B. the OSPF route
C. the RIPv2 route
D. all three routes
E. the OSPF and RIPv2 routes
Answer: A
New Questions 16
Which option is the main function of congestion management ?
A. providing long term storage of buffered data
B. queuing traffic based on priority
C. discarding excess traffic
D. classifying traffic
Answer: B
New Questions 17
Which two statements about unique local IPv6 addresses are true?
A. They are identical to IPv4 private addresses.
B. They are defined by RFC 1884.
C. They use the prefix FEC0::/10
D. They use the prefix FC00::/7
E. They can be routed on the IPv6 global internet.
Answer: A,D
New Questions 18
Which 2 statements about extended traceroute command is true?
A. it can send packets from specified interface or ip address
B. it can use a specified TTL value.
C. it can validate the reply data.
D. it can use a specificed TOS.
E. it can repeated automatically to a specified interval.
Answer: A,B
Explanation: Reference:
http://www.cisco.com/c/en/us/support/docs/ip/routing-information-protocol-rip/13730- extpingtrace.
html#ext_troute
u201cThis table lists the traceroute command field descriptions:
Source address: The interface or IP address of the router to use as a source address for the probes. The
router normally picks the IP address of the outbound interface to use.
Minimum Time to Live [1]: The TTL value for the first probes. The default is 1, but it can be set to a higher
value to suppress the display of known hops.
Maximum Time to Live [30]: The largest TTL value that can be used. The default is 30. The traceroute
command terminates when the destination is reached or when this value is reached.
New Questions 19
How does a Cisco switch respond if you boot it without a valid configuration in the NVRAM?
A. it enters setup mode.
B. it uses the running u2013configuration
C. It prompts you to restore the startup configuration
D. it enters user EXEC mode.
Answer: B
New Questions 20
Which port security mode can assist with troubleshooting by keeping count of violations?
A. access.
B. protect.
C. restrict.
D. shutdown.
Answer: C
New Questions 21
At which layer of the OSI model does the protocol that provides the information that is displayed by the show cdp neighbors command operate?
A. data link
B. application
C. network
D. transport
E. physical
Answer: A
New Questions 22
which option is the correct CIDR notation for 192.168.0.0 subnet 255.255.255.252?
A. /29
B. /30
C. /31
D. /32
Answer: B
New Questions 23
Refer to the exhibit, you determine that Computer A cannot ping Computer Which reason for the problem is most likely true?
you determine that Computer A cannot ping Computer. Which reason for the problem is most likely true?
A. The Subnet mask for Computer A is incorrect.
B. The default gateway address for Computer A is incorrect.
C. The subnet mask for computer B is incorrect.
D. The default gateway address for computer B is incorrect.
Answer: A
Explanation:
255.255.255.224 =/27
New Questions 24
Which address block identifies all link-local address
A. fc00::/7
B. fc00::/8
C. fe80::/10
Answer: C
Recommend!! Get the Download 200-125 dumps in VCE and PDF From Allfreedumps, Welcome to download: https://www.allfreedumps.com/200-125-dumps.html (New 890 Q&As Version)