Question No: 8

Which type of routing protocol operates by exchanging the entire routing information ?

A. distance vector protocols

B. link state protocols

C. path vector protocols

D. exterior gateway protocols

Question No: 9

Which two steps must you perform on each device that is configured for ipv4 routing before you implement OSPFv3? (chooose two)

A. configure an autonomous system number

B. configure a loopback interface

C. configure a router ID

D. enable IPv6 on an interface

E. enable IPv6 unicast routing

Question No: 10

which command can you enter to re enable cisco discovery protocol on a local router after it has been

disabled ?

A. Router (config)# cdp run

B. Router (config-if)# cdp run

C. Router (config)# cdp enable

D. Router (config-if)# cdp enable

Question No: 11

refer to the exhibit , on R1, which routing protocol is in use on the route to 192.168.10.1?

A. EIGRP

B. OSPF

C. RIP

D. BGP

Question No: 12

Where does a switch maintain DHCP snooping information?

A. in the CAM table

B. in the VLAN database

C. in the DHCP binding database

D. in the MAC address table.

Question No: 13

Refer to the exhibit.

After you apply the given configuration to R1, you notice that it failed to enable OSPF Which action can you take to correct the problem?

A. Configure a loopback interface on R1

B. Enable IPv6 unicast routing on R1.

C. Configure an IPv4 address on interface FO/0.

D. Configure an autonomous system number on OSPF.

Question No: 14

which port security mode can assist with troubleshooting by keeping count of violations?

A. access.

B. protect.

C. restrict.

D. shutdown.

Question No: 15

which six-byte field in a basic ethernet frame must be an individual address ?

A. FCS

B. SOF

C. SA

D. DA

Question No: 16

Which type of MAC address is aged automatically by the switch?

A. automatic

B. manual

C. dynamic

D. static

Question No: 17

Refer to the exhibit,

you determine that Computer A cannot ping Computer Which reason for the problem is most likely true?

A. The Subnet mask for Computer A is incorrect

B. The subnet mask for computer B is incorrect

C. The default gateway address for Computer A is incorrect.

D. The default gateway address for computer B is incorrect.